Rose-electronic Vista Mini Manuale Utente

VISTA MINIDESKTOP KVM SWITCH WITH AUDIOInstallation andOperation ManualELECTRONICS10707 Stancliff Road n Houston, Texas 77099Phone: (281) 933-7673 n I

INSTALLATIONStep 1. Connecting monitor, keyboard, and mouse1.1 Plug the monitor, keyboard, mouse, and speaker cables directly intothe rear panel of th

WARNING: Avoid routing cable near fluorescent lights, air conditioningcompressors, or machines that may create electrical noise. For best qualityvideo

OPERATIONVista Mini is simple to operate. Computer selection and function commands areentered from the keyboard. You can also select computers manuall

grammable from 1-15 seconds. To stop scanning, press and release <Ctrl>,then type “X”. Scanning is also disabled by entering a computer selectio

when holding a key down to repeat the key, such as when moving a cursoracross a line. The rate is the speed at which the keys are sent in keys/second.

PS/2 to serial mouse translation, wheel mouseYou can use some computers with PS/2 mouse interfaces and some computerswith serial interfaces. You must

ROM Identification commandThis command is used to identify the revision level of Vista Mini firmware cur-rently installed. Before entering this comman

tion. To perform this operation, hold in the “1" switch on the front panel andpress and release the ”reset" switch. At least one CPU must be

KEYBOARD COMMAND SUMMARYTo enter any keyboard command, first press and release the left Control Key,represented by <Ctrl>. Then enter the comman

Reset com-mand<Ctrl> RResets and enables mouse and keyboard,enables PS/2 mouse on currently selectedport.Send null tomouse<Ctrl> NUsed to

LIMITED WARRANTYRose Electronics warrants the Vista MiniTMto be in good working order for one year from the date ofpurchase from Rose Electronics or a

TROUBLESHOOTING1. CPU does not boot, keyboard error receiveda. Cable is loose, reseat cable and hit F1 to continue or reboot com-puter.b. Wrong cable

b. PS/2 mouse was not connected when Vista Mini powered up or hasbeen disconnected and reconnected. Issue the reset command.c. Mouse translation set i

APPENDIX A. FACTORY DEFAULT SETTINGSSetting DefaultScan enable OffScan Time Interval 5 secondsCaps/Numlock/Scroll Numlock OnKeyboard Mode 2Typematic V

CONTROLS Reset switch, computer select switchINDICATORS Status LED, computer select LEDs 1-2, computerpower LEDs 1-2APPENDIX C. CABLESDescription Part

ELECTRONICS10707 Stancliff Road n Houston, Texas 77099Phone: (281) 933-7673 n Internet: www.rosel.com

TABLE OF CONTENTSINTRODUCTION...1FEATURES ...1GETTING STARTED ...2Package contents ...

Appendix A. Factory default settings ...18Appendix B. General specifications ...18Appendix C. Cables and accessories ...19

INTRODUCTIONThank you for choosing Vista Mini™. Designed for plug-and-play operation,your new Vista Mini switch simplifies your job by helping you org

GETTING STARTEDTo acquaint you with your Vista Mini unit, this manual first describes Vista Mini’sfront and rear panels. Then follow the installation

Most installations use cable no longer than 20 feet in length. Cable length will af-fect the quality of the video, depending upon which resolution you

VIStA MINI HARDWAREThe front panelThe Vista Mini front panel features five LEDs and two switches. To familiarizeyourself with Vista Mini’s controls an

The connectorsAll cables are connected at the Vista Mini’s side and rear panels. The side pan-els are used to connect to the computers. The rear panel